[Exclusive] iPhone 14 Pro CAD renders reveal hole-punch camera, triple rear cameras, and more

iPhone 14 Pro CAD renders are here

Firstly, iPhone 14 Pro CAD renders confirm that the bathtub notch is going away. In its place, there will be a pill-shaped hole-punch cutout and a small circular cutout right beside it. The cutouts will house the Face ID sensors and selfie camera. The front has symmetrical bezels on all corners, with the top bezel accommodating the speaker grille. This gives the device a much premium look. The power button is on the right, while the volume rocker, SIM tray section, and alter slider are on the left edge.

The rear design is quite identical to the iPhone 13 Pro. There is a huge square-shaped module to house triple camera sensors, an LED flash, a microphone, and a LiDAR sensor. The bottom edge has speaker grills, a microphone, and a lightning port for charging. The iPhone 14 Pro has 5g Antenna cutouts all around. The iPhone 14 Pro could come in the same colour options as the iPhone 13 Pro, including the new Green colour that was announced at the Peek Performance event. 

Our source has revealed the iPhone 14 Pro will retain the same 6.1-inch display size as the iPhone 13 Pro. We believe it will also retain the 120Hz ProMotion OLED display. The iPhone 14 Pro (and 14 Pro Max) will reportedly be powered by the new A16 Bionic chipset and 6GB RAM. Meanwhile, the vanilla iPhone 14 models will get the typical notch and A15 Bionic SoC.

The iPhone 14 Pro models are also expected to bring camera improvements as well, including a 48MP primary camera sensor. This is all we have for you. We should learn more about the iPhone 14 series in the coming week.